Solid control is very critical during the oil and gas drilling process, it will maintain the required property of the drilling mud and remove the low gravity solids from the liquid, and finally can make the drilling mud which could be reused and recycled in the drilling mud system. A good solid control process could increase the rate of penetration, reduce the wear and tear of the drilling equipment, such as the pistons, liners of the mud pump and allow for better hole cleaning.
The new composite framed shale shaker screens have the follow features: the steel frame part is welded automatically by robot with higher strength and better quality conformity. The injection molded plastic is mixed with imported fiberglass and it can resists high temperature up to 140 degree, and it’s tougher, more endurable and can work under higher vibration G force. . The heat press of the screens adopts the process of four side tensioning which can minimize the gap between the top and support screens and extend the life of the screens. GN’s shaker screens will be 3 layers with the API number above 60, while other screens manufacturer only use 3 layers until API number above 100. And GN’s mesh supplier is the same as DERRICK and MI SWACO’s. GN’s screen adopts the rectangular wire configuration and the wire is 50% more thicker than the square wire configuration, and it could be used up to 300-700 hours. GN’s composite screens cover GN’S OEM screen, MI SWACO MONGOOSE, BRANDT VENOM, BRANDT KING COBRA, FSI, etc. GN can also customize the screens according to customer’s requirement. All the composite screens are repairable. Comparing to steel framed screens, the non blank area of composite framed screen is 10-20% more. And the composite frame is not easily to get rusted and can be stored up to 5 years.
That’s the brief introduction about GN’s screen strategy. GN would like to hear from you. Welcome to visit www.gnsolidsamerica.com and please send your ideas to USA@gnsolidscontrol.com .